Ŀ ERMINAL MCS ķ (C) H.-J. Bhling 1997/98/99 Ľ Blowstr. 2 V08.99 D-40476 Dsseldorf germany Tel. : 0211/462482 e-mail: Boehling@mail.isis.de ttp://www.germany.net/teilnehmer/101.107378 ͸ A terminal-programme for all MCS-51-BASIC-systems ; The programme Terminal-MCS-51 is a terminal-programme for MS-DOS computers, which has been particular written for the using with MCS-51-BASIC computers. It offers you the possibility of comfortable MCS-51-BASIC programme development with the following capacity: - Easy loading and saving of MCS-51-BASIC-programmes - Renumbering of MCS-51-BASIC-programmes (only in registered version) - Comfortable MCS-51-BASIC-line-editor - Arbitrary ASCII-editor easy to integrate Terminal-MCS-51 needs the following minimal Hardware-requirements: - A MS-DOS-computer - Any video-card - A floppy- or hard-disk - A serial interface (COM1: or COM2:) - A MSC-51-BASIC-system (conected to the serial interface) MCS-51-BASIC ------------ The MCS-51-BASIC-interpreter has been developed by the company INTEL particularly for the 8052-AH microcontroler and fits with its size of only 8 Kbyte into the internal read only memory (ROM) of this processor. Meanwhile INTEL had placed this interpreter as freeware in the public domain and the commented sourcecode and HEX-file can be found in the Internet! But also the interpreter can copy itself with a MCS-51-BASIC-programme out of an existing 8052-AH into an EPROM. This copy will then also run with a reasonable 8032-CPU. I have developed a MCS-51-BASIC-computer, using a 80C52 CPU which has been published in the electronics & computer magazine "ELEKTOR", edition 2/98 and 3/98. The sum of commands of MCS-51-BASIC is a bit reduced in the string- processing, but still comfortabele. Unfortunately the command RENUM for renumbering the MCS-51-BASIC-linenumbers have been economized. The MCS-51-BASIC-line-editor makes only the delete of the last character of the lineinput possible.